Because of application requirements, some products will need to use double encoder to six feet, the encoder is not commonly used, how to do?
Today we take a look at six feet double encoder wiring method, six foot duplex coder using matters needing attention.
Six foot duplex encoder wiring method as we all know, the current single league encoder for 3 feet is commonly used as a single channel to adjust the volume, the grounding wire is usually 1 foot, then 2 feet (
That is in the middle of the pin)
Connect output terminal, 3 feet by output.
So for 6 foot duplex coder is usually used as a dual channel volume use.
Connection on the overall and 3 feet it actually wiring principle is the same as the encoder, the first six foot duplex coder 1 foot, and four feet are welding some ground at the same time, for the 2 feet is left sound channel output, 3 feet is feet left sound channel input, 5 feet right sound channel output, 6 feet right sound channel input can meet, so everyone for the single and double encoder wiring method to distinguish.
Six foot duplex coder using note 1.
In six feet of double encoder wiring, connection between the pins don't wrong, otherwise result in using encoder and may cause some phenomenon such as failures, and also could be easy to make the encoder is damaged.
Especially pay attention to when operating the encoder wiring so to make sure that the connection again.
2.
For rotational adjustment in duplex coder, don't too hard to turn the operating strength, whether the person on the inside of the encoder shaft will be easy to become loose, resulting in the encoder adjustment will cause either at a draught adjustment is small, or adjust a lot, and so on and so forth.
3.
On the installation of double encoder, for the connection of each pin, do not pull too much, or easy to pin from off the insulation of the encoder panel.
So for the installation of encoder is to pay more attention to all aspects.
4.
About double encoder can replace single use of encoder, can in principle, but for at the time of replacement, to invite relevant technical personnel to install, so as to avoid their possible when wiring wrong line, the cause was going to be easy to damage of encoder.
Shanghai electronic products co. , LTD. , is 27 years old coder manufacturer, specializing in the production of a variety of single encoder, double encoder, multigang encoder.
Complete a multiple-choice, encoder type can be perfect to replace encoder brand at home and abroad.
Factory has many kinds of adjustable rotary encoder, straight and smooth encoder, rocker encoder, dial encoder, switch, encoders, take the motor encoder.
According to customer needs to customize the encoder resistance linear dimensions, our goal is to make the customers absolutely satisfied!
Looking for looking for electronic encoder manufacturers.
Hello, this is Liz. If I am not online, please email me at heng@shhxgd.cn, or add my Whatsapp/ Wechat : +86 186-1688-3327, we will reply you as soon as possible~~
Hello, please leave your name and email here before chat online so that we won't miss your message and contact you smoothly.